If the flattened side of one of the modules is not in contact Will happen at the flat side of the draw length module that is used to adjust Them look to see if both cams are coming in contact with the cables or not. If you don’t have a draw board to check the timing of yourĬams, you can ask someone to look at the cams while you are at full draw. This is the draw board I used for years before purchasing the Inexpensively, you can watch the following video I produced to give you some If you would like to learn how to make your own draw board fairly Reviews and wanted a way to be able to check cam timing, draw length, and draw Got it simply because I travel around to many different bow shops doing bow Timing, I purchased mine from Lancaster Archery for several hundred dollars. Here is a link to the type of press I’m talking about if you want to check it out.Īs far as the draw board I was using to check the cam It should also be noted that my model is 15 years old so it is very possible that newer models will fit it, and people have told me that Bear has it listed as an approved press. I wanted to use that press because it is fairly inexpensive and just about anyone could probably afford one. I will also note that I initially attempted to do my adjustments using the Bowmaster Bow Press, but the cams were too large to work properly with mine. The draw board and the cam timing was perfect. To do this, I added one half twist to the cable on the cam that wasĬoming in contact with the cable before the other. One cam was hitting slightly before the other, so I set the cam I then put the bow on a draw board to see if the cams were The bow came set at 26-inch draw length, so I did my initial arrowįlight test there. The box by shooting an arrow through a paper tuner to see how accurate theįlight was. I then tested the tuning of the Bear Cruzer G2 right out of The end you may not be able to see it if you opened it on the opposite side The side, you will easily see the stabilizer and sling, but if you open it from Sling are so light that the box simply felt empty once the bow and otherĪccessories were taken out of the box. I actually shot this bow throughout the entire review without themīecause I didn’t know that compartment was there. Hidden compartment in the bottom where the stabilizer and wrist sling was Just cardboard, so it won’t last forever, especially if you are traveling withĪnother thing I learned about this box was that there was a You intend to use it as a portable bow case. Make sure you open the Bear Cruzer G2 box this way if To discover that the Bear Cruzer G2 box is designed to be laid down on its sideĪnd opened from the side. I opened theīox from the end like I’ve done any other bow box in the past. With a handle inside so that you can turn the bow into a bow case. Took the item out of the box and mounted the accessories. In this article, I am going to share with you my findingsĪfter completing an extensive review of the Bear Cruzer G2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |